Home / Blog

Blog

Practical guidance on predictive maintenance, equipment reliability, and plant optimization.

The Failure Reporting Analysis and Corrective Action System
Reliability Engineering Insights 13 min read

The Failure Reporting Analysis and Corrective Action System

In 2024, one hour of unplanned industrial downtime cost an average of approximately $25,000, rising above $500,000 per hour for…

Read Article →
High Bearing Temperature: Causes and Fixes
Reliability Engineering Insights 14 min read

High Bearing Temperature: Causes and Fixes

A steel-mill boiler-feed pump is running at steady load and speed, but its drive-end bearing housing reads 92°C while the…

Read Article →
Radial Deep Groove Ball Bearing Failure Causes and Fixes
Reliability Engineering Insights 16 min read

Radial Deep Groove Ball Bearing Failure Causes and Fixes

A motor comes out for the second time in nine months. The replacement bearing matched the bore, the load looked…

Read Article →
Condition Monitoring Predictive Maintenance Explained
Reliability Engineering Insights 12 min read

Condition Monitoring Predictive Maintenance Explained

The popular advice says to buy sensors first and let the software find the problems. That's backwards. Sensors don't prevent…

Read Article →
Thrust Needle Bearing Ratings and Failures
Reliability Engineering Insights 14 min read

Thrust Needle Bearing Ratings and Failures

“Keep the load below the catalog rating” is incomplete advice for a thrust needle bearing. A maintenance team can follow…

Read Article →
Motorized Valve Actuators: Failure Modes and Diagnostics
Reliability Engineering Insights 12 min read

Motorized Valve Actuators: Failure Modes and Diagnostics

The popular advice is simple. If a motorized valve trips on high current, replace the actuator. If it trips on…

Read Article →
Maintenance of Electric Motors: A 2026 Field Guide
Reliability Engineering Insights 13 min read

Maintenance of Electric Motors: A 2026 Field Guide

Consider a 250 hp, 480 V induction motor driving a paper-mill exhaust fan for more than 6,000 hours a year.…

Read Article →
Central Lubrication System Guide for Uptime
Reliability Engineering Insights 13 min read

Central Lubrication System Guide for Uptime

The most popular advice on automatic lubrication is also the most dangerous version of it. Fit a pump, set a…

Read Article →
How to Build a Management of Change System
Reliability Engineering Insights 14 min read

How to Build a Management of Change System

The replacement chemical-transfer pump bolts to the existing base, the coupling lines up, and production wants it running before the…

Read Article →
Can Water Mix with Oil in Lubricated Machines
Reliability Engineering Insights 13 min read

Can Water Mix with Oil in Lubricated Machines

Water and oil do not form one liquid. Fresh water sits near 1.00 g/cm³, and a documented light hydrocarbon phase…

Read Article →

Get Started

Request a Free Reliability Assessment

Tell us about your equipment and facility. Our reliability team will review your situation and recommend a tailored reliability program — no obligation.

Free initial assessment
Response within 1 business day
No obligation or commitment

No obligation. Typical response within 24 hours.

Ready to Improve Your Plant Reliability?

Tell us about your facility and a reliability specialist will review your situation.

Claim Your Free Assessment →